The symptoms can be one or more of the following. This will not affect the 2-meter band on the series. But many times, the only noticeable issue is the transmitter will tend to oscillate intermittently on the higher HF bands 6, 10, or 12 meters. Important Note: Although I have first-hand knowledge of the damaged circuitry and the necessary repairs, I only have second-hand knowledge as to the cause of damage, which was acquired by interviewing customers about their station setups and operating practices. You should be aware of the fact that transmitter is set to transmitt on amateur bands only band-pass filtersso transmitting outside of those frequencies have to be with limited power only, or you can easily demage the transmitter!Sometimes, components on the RF Unit may also be affected. Of course, transmitting outside the amateur frequencies are not allowed neither for licenced radio amateurs! It will restart automatically and voila! The transmitter is "unloicked" now, and will be able to transmitt on all frequencies from about 0. After you have removed diodes as shown on above pictures, return the DSP-module, return the botom cover into its place and turn on the transceiver. Nonton film indonesiaĬarefully using a magnifying glass you should remove the diodes located at the PCB as shown on the picture below. Carefully unplug DSP-unit and place it aside. There is DSP-unit plug in metal box on the right side. Place the transceiver on the table with face toward you, upside down. This modification allows transmitter to transmit on whole frequency range.
![icom 756 pro 3 serial numbers icom 756 pro 3 serial numbers](https://www.dxzone.com/dx32739/icom-ic-756-pro-ii-review.jpg)
Transmitter is factory limited to transmit on amateurs bands only. It can receive from 30 kHz up to 60 MHz continuously and transmit all mode, all bands with watts RF power output.